whemap.blogg.se - Programming genie intellicode remote acsctg type 3

Follow accompanying instructions for "Programming to IntelliCode 1 Genie garage door opener," or see below instructions: You are now ready to program the remote to your garage door. The IntelliCode selection for this button is set to IntelliCode 1.

Press the same button again to confirm toggle.

Press the same button twice to toggle IntelliCode selection from IntelliCode 2 to IntelliCode 1.

Both Red and Green LEDs come on and stay on.

Press and hold that button for 10 seconds.

Select a button on the remote that has not been programmed.

To set one of the 3 buttons to be IntelliCode 1 (red), follow the instructions below:

Red = IntelliCode 1 / Green = IntelliCode 2 An LED light on the remote displays which mode the remote button is in:

To change a button to operate a pre 2011 IntelliCode opener, the default IntelliCode 2 setting must be changed to IntelliCode 1. This remote is defaulted to operate the new IntelliCode 2 Genie garage door openers, but you can also program individual buttons to operate other IntelliCode 1 (pre 2011) models of Genie garage door openers made from 1998 to present. This is a 3 button remote, which can be used to operate up to 3 garage doors using IntelliCode radio controls. Here's how:īackwards compatable programming instructions for GT3-R dual-band remote: (315/390) You need to select one button to program the TYPE 1 frequency of 390 MHz.